Hanns.G JW199D User Manual download pdf (Page 22)

User’s Manual

ERROR MESSAGE & POSSIBLE SOLUTIONS

 CABLE NOT CONNECTED :

1. Check that the signal-cable is properly connected, If the connector is loose, tighten

the connector’s screws.

2. Check the signal-cable’s connection pins for damage.

 INPUT NOT SUPPORT :

Your computer has been set to unsuitable display mode, set the computer to display

mode given in the following table.

FACTORY PRESET TIMING TABLE:

VGA 720 x 400 @ 70Hz

VGA 640 x 480 @ 60Hz

MAC 640 x 480 @ 67Hz

VESA 640 x 480 @ 75Hz

VESA 800 x 600 @ 56Hz

VESA 800 x 600 @ 60Hz

VESA 800 x 600 @ 72Hz

VESA 800 x 600 @ 75Hz

MAC 832 x 624 @ 75Hz

VESA 848 x 480 @ 60Hz

VESA 1024 x 768 @ 60Hz

VESA 1024 x 768 @ 70Hz

VESA 1024 x 768 @ 75Hz

VESA 1280 x 720 @ 60Hz

VESA 1280 x 960 @ 60Hz

VESA 1280 x 768 @ 60Hz

VESA 1280 x 768 @ 75Hz

VESA 1280 x 1024 @ 60Hz

VESA 1280 x 1024 @ 75Hz

VESA 1360 x 768 @ 60Hz

VESA 1440 x 900 @ 60Hz

VESA 1440 x 900 @ 75Hz

1 2 ... 17 18 19 20 21 22 23

No comments

Hanns.G JW199D User Manual Page 22