Hanns.G HL221 User Manual download pdf (Page 8)

User’s Manual

INSTALLATION INSTRUCTIONS

INSTALL & REMOVE

Figure.1. Installing and Removing the Base

INSTALLATION:

1. Turn the monitor over and set it upside down.

2. Align the monitor to the slots on the stand.

3. Please note that the longer edge of the stand should be facing forward.

4. Pull the screw ring upwards, then turn the screw clockwise to secure. When the stand is securely

attached to the monitor, pull down the screw ring to flatten it with the base of the screw.

5. Check the underside of the stand to ensure that the monitor has been firmly installed to the stand

and that the screws do not loosen.

REMOVAL:

1. Turn the monitor over and set it upside down.

2. Turn the screw counterclockwise to loosen it.

3. Detach the stand from the monitor.

POWER

POWER SOURCE:

1. Make sure that the power cord is the correct type required in your area.

2. This adapter has an Internal universal power supply that allows operation in either

100/120V AC or 220/240V AC voltage area (No user adjustment is required.)

3. Plug one end of the 12V DC adapter to the LCD monitor’s DC 12V input socket, plug one end of

the AC power cord to the 12V DC adapter AC input socket, and the other end of the AC power

cord to Wall outlet.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

No comments

Hanns.G HL221 User Manual Page 8